Private Integrated Services Network (PISN)
- Inter-Exchange Signalling Protocol - Advice of Charge Supplementary
3rd edition (December 2001)
This Standard specifies the signalling protocol for the support of the Advice Of Charge supplementary services (SS-AOC) at the Q reference point between Private Integrated services Network eXchanges (PINX) connected together within a Private Integrated Services Network (PISN).
SS-AOC is a set of supplementary services which enable a user to receive information about the charging of its calls that leave the PISN and enter another network.
The three AOC supplementary services are:
Charging information at call set-up time (AOC-S) SS-AOC-S enables the user to receive information about the charging rates at call set-up time and also to receive further information during the call if there is a change of charging rates.
Charging information during the call (AOC-D) SS-AOC-D enables a user to receive information on the recorded charges for a call during the active phase of the call.
Charging information at the end of the call (AOC-E) SS-AOC-E enables a user to receive information on the recorded charges for a call when the call is terminated.
The Q reference point is defined in ECMA-133
Service specifications are produced in three stages and according to the method specified in ETS 300 387. This Standard contains the stage 3 specification for the Q reference point and satisfies the requirements identified by the stage 1 and stage 2 specifications in ECMA-211.
The signalling protocol for SS-AOC operates on top of the signalling protocol for basic circuit switched call control, as specified in ECMA-143, and uses certain aspects of the generic procedures for the control of supplementary services specified in ECMA-165.
This Standard also specifies additional signalling protocol requirements for the support of interactions at the Q reference point between SS-AOC and other supplementary services and ANFs.
Additional interactions that have no impact on the signalling protocol at the Q reference point can be found in the relevant stage 1 specifications.
This Standard is applicable to PINXs which can interconnect to form a PISN.
The protocol defined in this Standard forms part of the
PSS1 protocol (informally known as QSIG).
The following file can be freely downloaded:
||Acrobat (r) PDF file
This Ecma publication is also approved as ISO/IEC 15050.
The previous replaced "historical" editions of this Ecma Standard are available here.